Project W001 - STEP 2 - Printing the Parts

STEP 2 - Printing The Parts

On the right side of the screen we see the pieces as they will be printed out. We need to change our paper size to match what we will be used. We used Letter paper to print out pieces.


To change your print settings - File - Print and Paper Settings

Set your configuration to match this screen. This will allow you to print all of your pieces in the right scale and be clear and easy to cut.

If your pieces shifted on the right side of the screen, simply move them so they are only on 1 piece of paper. In most cases you can have multiple pieces on the same sheet of paper to print.

HINT - To keep pieces from overlapping and causing conflicts - 2D Menu - Check Overlapping Parts should be enabled. If any parts are too close they will show in red. Click the pieces and move them until they are not red.

When ready Print!